Fix Advices
2015 Hyundai Veloster L4 1.6L_How to Use the Front Wipers and Washers
Written by R&D
September 16, 2026
Introduction
The front wipers and washers on the 2015 Hyundai Veloster L4 1.6L are essential features designed to ensure clear visibility during adverse weather conditions such as rain, snow, or dirt accumulation. This system allows drivers to easily clean the windshield, enhancing safety and convenience during their journey. Proper usage of the front wipers and washers not only contributes to better visibility but also helps maintain the longevity of the wiper blades. This article provides a detailed, step-by-step guide on how to effectively use front wipers and washers on your 2015 Hyundai Veloster L4 1.6L.
How to Use the Front Wipers and Washers
Warning
Important Note About Washer Fluid Usage
If the temperature outside is below freezing, make sure to use the defroster to warm the windshield. This will help prevent the washer fluid from freezing on the glass, which could block your view and potentially lead to an accident, causing serious injury or even death.
Important Note About Front Wipers Usage
- To avoid damaging the washer pump, ensure the fluid reservoir is not empty before using the washer.
- To protect the wipers and windshield, refrain from using the wipers on a dry windshield.
- To prevent harm to the wiper arms and other parts, do not try to move the wipers by hand.
Operation of the Front Wipers
The front wipers are activated by moving the control lever to specific positions. The control lever functions as described when the ignition switch is turned to the ON position:
A: Adjusting the wiper speed
- MIST (Momentary Mode): To activate a single wipe, push the lever upward and then release it. If you hold the lever in this position, the wipers will continue to operate.
- OFF: This mode turns off the windshield wipers completely.
- INT (Intermittent Mode): The wipers function intermittently at consistent intervals. To adjust the speed, turn the speed control knob (B).
- LO (Low-Speed Mode): The wipers move at a steady, slow speed.
- HI (High-Speed Mode): The wipers function at a fast, continuous speed.
B: Adjusting the wipe interval for Intermittent or Auto mode
C: Wash with short wipes
NOTE: If there is a significant buildup of snow or ice on the windshield, defrost it for approximately 10 minutes, or until the snow and ice are cleared, before using the windshield wipers to ensure they function correctly.
Windshield Washer Operation
When the switch is in the OFF position, gently pull the lever towards you to dispense washer fluid onto the windshield and activate the wipers for 1-3 cycles. Use this feature whenever the windshield is dirty. The spray and wipers will continue working until you release the lever.
NOTE: If the washer isn’t functioning, check the washer fluid level. If it is low, refill the washer reservoir with suitable non-abrasive windshield washer fluid. The filler neck for the reservoir is located at the front of the engine compartment, on the passenger side.
Looking for a car scanner?
Looking for a car scanner?
Take our quiz! It’s short, fun, and accurate.
Help Me Choose
