2012 Ford Fusion L4 2.5L_How to Operate the Speed Control System

As an Amazon associate, we earn from qualifying purchases.

The speed control system in the 2012 Ford Fusion is designed to provide a smoother, more convenient driving experience. This advanced feature allows you to set and maintain a consistent speed without constantly pressing the accelerator, reducing driver fatigue on long trips or highway drives. With easy-to-use controls located on the steering wheel, you can adjust your speed, resume previous settings, or deactivate the system as needed. Whether you're looking to enhance comfort on extended journeys or improve fuel efficiency, the speed control system in the Ford Fusion offers practicality and ease for every driver. This article provides a step-by-step guide on how to use it in your 2012 Ford Fusion L4 2.5L.

How to Operate Speed Control

WARNING

Do not use the speed control feature in road conditions with high traffic density or traffic jams, many curves, slippery roads or poor road surface quality.

System Overview

The speed control system uses buttons on the steering wheel to manage your speed:

• SET (+): Sets or increases the speed.
• SET (-): Decreases the speed.
• RSM (Resume): Restores the previously set speed.
• CNCL (Cancel): Temporarily pauses the speed control without erasing the set speed.
• ON/OFF: Turns the system on or off

Speed Control Settings

Basic Controls

1. Turn it On: Press the ON/OFF button. An amber light in the instrument cluster shows the system is active.

2. Set Your Speed: Accelerate to the desired speed, then press SET +. Take your foot off the accelerator, and the system will maintain your selected speed. A green light turns on to indicate it’s engaged.

Note: When driving on steep hills, the vehicle's speed might change briefly:

• If your speed increases while going downhill, you may need to use the brakes to slow down.
• If your speed drops by more than 10 mph (16 km/h) below the set speed while climbing uphill, the system automatically turns off.

Disengaging Speed Control

You can temporarily turn off the system by tapping the brake pedal, clutch pedal (for manual transmissions), or pressing CNCL (Cancel).

The previous speed remains saved, so you can resume it later.

Note: If you use the clutch to disengage, engine speed may increase momentarily, which is completely normal

Resuming a Set Speed

Press RSM (Resume) to return to the last saved speed.

Increasing the Set Speed with Speed Control System

To increase the set speed:

• Press and hold the SET + button until the vehicle reaches the desired speed, then release.
• To increase speed in small increments, press and release SET + for approximately 1 mph (2 km/h) per tap.
• Alternatively, accelerate to the desired speed using the accelerator pedal, then press and release SET + to set the new speed.

Reducing the Set Speed with Speed Control System

To reduce the set speed:

• Press and hold the – SET button until the vehicle slows to the desired speed, then release.
• To decrease speed in small increments, press and release – SET for approximately 1 mph (2 km/h) per tap.
• Alternatively, apply the brake or clutch pedal (if equipped) until the desired speed is reached, then press SET + to set the new speed.

Turning Off Speed Control Completely

Press OFF or turn off the vehicle ignition.

Note: Turning off the speed control system or ignition erases the saved speed.

Back to Blog Academy